Daikin D-BACS - 1.5 Dio Unit (DEC102 A51)

282 1.2 <KRP2A61 / KRP2A62 / KRP2A53> Wiring Adaptor for Electrical Appendices (1)
Adaptor
(5) Setting control mode selector switch (RS1)
Using control mode selector switch (RS1), select the control mode as described below.
1 When operating with only individual display function
2 When operating with constant input from A
Note:
 Input B is for forced-OFF. When ON, stop + remote controller is rejected, and input A is ignored. When OFF, even if A
is ON, the contents of when input A is ON, are not achieved. Input A must therefore be re-input.
C : 1PA63642B
3 When operating with pulse input from A
(Use a pulse input of ON time 200 milli-sec. or longer.)
Position Function
0 Individual Display (Input Ignored)
CONTROL
MODE
Position
Function
Input A ON Input A OFF Input B ON
Operation
or not of
indoor
unit
From Remote
controller
Operation
or not of
indoor
unit
From Remote
controller
Operation or not
of indoor unit
From
Remote
Controller
1
Remote Control
Rejection
ON Rejection
OFF Rejection Forced OFF
Rejection
2 Central Priority ON Acceptable
3
Stop by Remote
controller Acceptable
ON
Only Stop
acceptable
4
Remote controller
acceptance / rejection
Permit Acceptable
Position Function
Input A ON Constant Input B ON (Input A is ignored)
Operation or
not of indoor
unit
From Remote controller
Operation or
not of indoor
unit
From Remote controller
5 Remote Control Rejection ON/OFF Rejection
Forced OFF Rejection
6 Last command Priority ON/OFF Acceptable
RS1
RS1
1
Input A
Input B
B1
B2
BC