Danfoss VACON NXP IP00 - Page 162

•
•
•
•
•
•
•
•
•
•
•
•
12.12.62 Fault 22 - Parameter fault, Subcode S3 - System power down variable check sum error
Cause
Parameter save fault.
Operation malfunction
defective component
Troubleshooting
If the fault occurs again, ask instructions from the local distributor.
12.12.63 Fault 22 - Parameter fault, Subcode S4 - System parameter checksum error
Cause
Parameter save fault.
Operation malfunction
defective component
Troubleshooting
If the fault occurs again, ask instructions from the local distributor.
12.12.64 Fault 22 - Parameter fault, Subcode S5 - Application-defined power-down, variable check-
sum error
Cause
Parameter save fault.
Operation malfunction
defective component
Troubleshooting
If the fault occurs again, ask instructions from the local distributor.
12.12.65 Fault 22 - Parameter fault, Subcode S6 - Application-defined power-down, variable check-
sum
Cause
Parameter save fault.
Operation malfunction
defective component
Troubleshooting
If the fault occurs again, ask instructions from the local distributor.
12.12.66 Fault 22 - Parameter fault, Subcode S10 - System parameter checksum error
Cause
Parameter save fault.
Operation malfunction
defective component
Troubleshooting
If the fault occurs again, ask instructions from the local distributor.
12.12.67 Fault 22 - Parameter fault, Subcode S13 - Checksum error in application-specific parame-
ter set
Cause
Parameter save fault.
Troubleshooting
Recommission the application.
Check parameters.
AQ351737303996en-000201 / DPD00888162 | Danfoss A/S © 2023.09
Specifications
VACON® NXP IP00 Drive Modules
Operating Guide