74 Magellan™ 3300HSI
Keyboard Wedge (continued)
Wedge Quiet Interval
NOTE
This feature does not apply to the USB Keyboard
interface.
Quiet Interval is the amount of time to look for keyboard activity before the
scanner breaks the keyboard connection in order to transmit data to the host.
START / END
PROGRAMMING bar codes
Selectable from 001 to 100 in 10 msec increments. To configure this feature, scan the “START/END” bar
code above to place the unit in Programming Mode, then the Set Wedge Quiet Interval bar code fol-
lowed by the three digits (zero padded) from the Alphanumeric table in Appendix C,
representing your
desired length. Exit programming mode by again scanning the “START/END” bar code above.
DEFAULT SETTING FOR THIS FEATURE:
010 (100 msec)
Set Wedge Quiet Interval
To Next Page
Loading...
