RS20i Installation and Operating Guide Page E-9
Appendix E. Remote Command API Document #: 9301H52900 Ver. 1.02
Table 2. Auro Configurations
Speaker
Configuration
Channel Sequence
Auro 9.1 L C R Rs Ls HL HR HRs HLs
Auro 10.1 L C R Rs Ls HL HR HRs HLs T
Auro 11.1 L C R Rs Ls HL HC HR HRs HLs T
Auro 11.1
(7+4)
L C R Rs Ls HL HR HRs HLs
Auro 13.1 L C R Rs Rb Lb Ls HL HC HR HRs HLs T
Auro 13.1 with
phantom HC
L C R Rs Rb Lb Ls HL HR HRs HLs T
Example
Start automatic pink noise sequence.
Send: @NOISESEQ 1<cr>
Receive: NOISESEQ 1<cr>
Turn off pink noise.
Send: @NOISESEQ 0<cr>
Receive: NOISESEQ 0<cr>
Audio Decoder Configuration
11. Post Processing Mode
Select post processing function between None, DTS NeoX, Dolby Pro Logic II or IIx,
Dolby Pro Logic IIz, or Auro-3D.
The option for Pro Logic IIz is only valid for speaker configurations that include front
left/right high speakers. If Pro Logic IIz is selected for a speaker configuration without
these speakers, the system defaults to operating as if None were selected for the
processing mode.
Command: @DECODERPOST [mode]<cr>
Operation
Response: DECODERPOST [mode]<CR>
Read/Write
Parameters
[mode] Selection
Valid Speaker Configurations
0
Off/None Any
3
DTS Neo:X All, except 2.0 or 2.1
4
Dolby PLII, or
Dolby PLIIx
Not Available for 2.0 or 2.1
PLIIx for all configuration with LB/RB
PLII for all other configurations
5
Dolby PLIIz Must include High Left / High Right
6
Auro-3D Auro 9.1, Auro 10.1, Auro 11.1 or Auro
13.1, 2.0, 2.1, 5.1, 7.1
To Next Page
Loading...
