Datasat RS20i - 22. Dolby DRC Setting; 23. DTS LFE Boost; 24. PCM LFE Boost

RS20i Installation and Operating Guide Page E-14
Appendix E. Remote Command API Document #: 9301H52900 Ver. 1.02
Parameters:
[value] Selection
0
Stereo
1
Surround
2
Auro-3D (Valid only with one of the
Auro speaker Configurations
22. Dolby DRC Setting
Command: @TRUEHDDRC [drc]<cr>
Response: TRUEHDDRC drc<CR>
Read/Write
Parameters:
drc Selection
0
DRC Off
1
On / TrueHD-Auto
2
DRC On
LFE Boost
23. DTS LFE Boost
Enable 10dB gain to the subwoofer outputs when playing DTS audio
Command: @ DECODERDTSLFEBOOST [dtslfe]<cr>
Response: DECODERDTSLFEBOOST [dtslfe]<CR>
Read/Write
Parameters:
dtslfe Selection
0
Do not apply 10dB gain for DTS
1
Apply 10dB gain for DTS
24. PCM LFE Boost
Enable 10dB gain to the subwoofer outputs when playing PCM audio
Command: @ DECODERPCMLFEBOOST [pcmlfe]<cr>
Response: DECODERPCMLFEBOOST pcmlfe<CR>
Read/Write
Parameters:
pcmlfe Selection
0
Do not apply 10dB gain for PCM
1
Apply 10dB gain for PCM