Datasat RS20i - 25. Dolby LFE Boost; 26. Decoder Stream; 27. Decoder Channels

RS20i Installation and Operating Guide Page E-15
Appendix E. Remote Command API Document #: 9301H52900 Ver. 1.02
25. Dolby LFE Boost
Enable 10dB gain to the subwoofer outputs when playing Dolby Digital decoded audio
Command: @ DECODERDDLFEBOOST [ddlfe]<cr>
Response: DECODERDDLFEBOOST ddlfe<CR>
Read/Write
Parameters:
ddlfe Selection
0
Do not apply 10dB gain for Dolby
Digital
1
Apply 10dB gain for Dolby Digital
Audio Decoder Stream Information
26. Decoder Stream
Returns a text description of the stream type currently playing
Command: @DECSTREAM<cr>
Response: [Desc]<CR>
Read/Write
Parameters:
[Desc]
Description of the current audio stream type being received by the decoder.
Example
Send: @DECSTREAM<cr>
Receive: DTS 48k + NeoX <cr>
27. Decoder Channels
Returns a text description of the number of channels at the decoder output. This does
not include additional channels from processing by Auro Decoder or Upmix, DTS NEO:X
or Dolby PLIIx/PLIIy.
Command: @DECCHANS<cr>
Response: [n.s]<CR>
Read/Write
The string [n/m/.s] appears only when the decoder is running. In that case the values n,
m, and s are defined as follows.
[n]
Number of front channels at the decoder output.
[s] The value is 1 when there is a decoder subwoofer output. Otherwise it is 0.
Example
Send: @DECCHANS <cr>
Receive: 7.1 <cr>