Figure 10.1 Example communication screen
See Hardware characteristics, DEIF Ethernet network in the Designer's handbook for more information
regarding the communication possibilities.
Setting Range Default Notes
Controller ID 1 to 64 1
When you change the
controller ID using the
display unit, you must also
update the controller ID in
the PICUS single line
diagram.
The system can have up to
12 controllers, with controller
IDs in the given range.
Label
Text No default
IP address mode Static, Auto Auto
Select Static to specify an
IPv4 address.
IPv4 address 0.0.0.0, 255.255.255.255 * No default
Static IPv4 address for the
controller.
Netmask 0.0.0.0, 255.255.255.255 * No default Depends upon IPv4 address.
Gateway 0.0.0.0, 255.255.255.255 * No default
* Note: This is the range of addresses that you can select. The range of addresses that you can actually use depends on
your network design. If you select Static, then you must give the controller a unique IPv4 address. In addition, some
addresses in this range are reserved.
Reviewing communication information
To view the communication information, perform the following steps:
PPM 300 Operator's manual 4189340910 UK
To Next Page
Loading...
