2.2.2
Operator information messages
Table 2.2 Controller types
Icon Notes
GENSET controller
EMERGENCY genset controller
SHAFT generator controller
SHORE connection controller
BUS TIE breaker controller
Operator info Additional information
1st priority not
possible in SWBD
While the controller is under switchboard
controller, operator actions cannot be
performed from the controller interfaces.
●
Alarm blocking BTB
close
A block alarm is active. Clear the alarm
before attempting to close the bus tie
breaker.
●
Alarm blocking engine
start
A block alarm is active. Clear the alarm
before attempting to start the genset.
● ●
Alarm blocking GB
close
A block alarm is active. Clear the alarm
before attempting to close the generator
breaker.
● ●
Alarm blocking SCB
close
A block alarm is active. Clear the alarm
before attempting to close the shore
connection breaker.
●
Alarm blocking SGB
close
A block alarm is active. Clear the alarm
before attempting to close the shaft
generator breaker.
●
Alarm blocking TB
close
A block alarm is active. Clear the alarm
before attempting to close the tie breaker.
●
Already first priority
Controller is already the first priority
controller.
●
Already selected
The command has already been received.
The controller is busy synchronising the
breaker.
●
PPM 300 Operator's manual 4189340910 UK
www.deif.com Page 17 of 157
To Next Page
Loading...
