◦ If the setting is a selection, pressing OK displays an available list of selection options.
◦ Highlight the option required, by pressing Up or Down .
◦ Select or unselect the option, by pressing OK .
◦ To confirm the setting, select Next
.
c. Once you have made all the required changes to the alarm settings, select Write
.
◦ This saves the alarm setting to the controller. This does not save any other settings.
◦ The list of available alarms is shown again on the display.
3. To save the new setting to the controller, select Write
.
• This only saves the selected alarm(s) and their settings to the controller. It does not save other I/O settings.
Clear all enabled alarm(s)
1. To clear all the selected alarms, select Clear
.
2. To save the new setting to the controller, select Write
.
• This only saves the selected alarm(s) and their settings to the controller. It does not save other I/O settings.
7.8.6 View or configure sensor
INFO
Configure any required function(s) before configuring the sensor settings.
See Analogue input (AI), Configure function(s) for more information.
Configure the Sensor
1. To configure the Sensor, select Sensor
.
• A list of available output types are shown on the display.
•
PPM 300 Operator's manual 4189340910 UK
To Next Page
Loading...
