Configure functions
1. To select the functions for the terminal:
• Highlight the required function, by pressing Up or Down .
• Enable the highlighted function, by pressing OK .
◦ Selected function(s) are shown with a solid box.
• To clear all the Enabled functions, select Clear
.
• To save the setting(s) to the controller, select Write
.
◦ This only applies to the selected functions and does not apply other I/O change(s).
7.7.4 Configure alarms
The alarms available for a digital output (DO) are organised in to categories and groups, which are similar to a tree structure
view.
INFO
When viewing or configuring a previously configured I/O with an alarm, the display will automatically jump to the
alarm settings. You can, if required, use Back to return to the alarm selection screen.
Selecting an alarm
1. Highlight a category or group, by pressing Up or Down .
2. Select the highlighted category or group, by pressing OK
.
• A further group may be shown or the alarm list to select the actual alarm(s).
• If a further group is shown, simply repeat step 1 to locate and open the required group.
3. Highlight the required alarm, by pressing Up or Down .
• Details of the alarm settings are shown at the right side of the display.
PPM 300 Operator's manual 4189340910 UK
www.deif.com Page 79 of 157
To Next Page
Loading...
