Deif PPM 300 - Controller Type; Prerequisites; Change Controller Type

6. Further information is displayed by pressing OK on a highlighted user.
10.6 Controller type
10.6.1
Prerequisites
CAUTION
Before attempting to change the controller type, the following prerequisites MUST be adhered to.
You can only change the controller type if is is safe for commissioning, that is to say:
1. The engine must be stopped (Not applicable to BUS TIE breaker controller)
2. The breaker must be open.
3. The controller must be in switchboard control.
OR
1. The controller is in Emulation mode.
10.6.2 Change controller type
Change the
Controller type under Tools > Advanced > Change type.
CAUTION
The controller type must only be changed if it is safe for commissioning, and the prerequisites are adhered to.
INFO
Access to this feature requires the necessary permission access.
PPM 300 Operator's manual 4189340910 UK
www.deif.com
Page 136 of 157