Desoutter CVI3 Vision User Manual

6159930310_07_01/2016- 18 -
4.6.2 - Display parameters
Display
mode
Torque
Torque & angle results are on the
tool display.
Angle
Batch
count
Batch count and batch size are on
the tool display (xx/xx).
Ellipse
The Assembly Process ellipse is on
the tool display.
Sound
enabled
• Click to enable the parameter.
Voice messages and beeps have been created
to alert the operator in case of problems or
events that may happen during the tightening
operation.
Tool power
saving
mode
Tool display
standby
After 2 minutes, the wireless
battery tool display switches
off.
Communication
standby
The wireless battery tool
communication with the
controller goes down.
• Set the value between
[5;60].
Power off
25 minutes later, the wireless
battery tool powers off.
• Enter "0" to keep the communication always
active. The wireless battery tool will never
power off.
4.6.3 - Network parameters
Communication
port
The communication port is used by
the controller to communicate with the
wireless battery tool.
7477 by default.
• In the WI-FI conguration of the battery
tool, check that the communication port
is the same.
• Refer to the CVIMONITOR user manual
at http://resource-center.desouttertools.
com.

Desoutter CVI3 Vision Specifications

General

Brand	Desoutter
Model	CVI3 Vision
Category	Controller
Language	English