6159930310_07_01/2016 - 45 -
11 - MAINTENANCE
11.1 - Controller
11.1.1 - USB key - Firmware upgrade
Path: Main menu / Maintenance / Controller / USB
• Copy the ".cvi3" image to the root of your USB key.
• Check there is 1 ".cvi3" image only on your USB key.
• Copy the ".cvi3.md5" le to the root of your USB key.
• Check there is 1 ".cvi3.md5" le only with the same release
number on your USB key.
• Plug the USB key to the front panel port.
• Tap "Upgrade SW".
The controller beeps during 2 seconds and starts the process.
• Do not switch off the controller.
• Wait for the automatic reboot. The update lasts a few
minutes.
When the upgrade is successful, the green LED is on.
11.1.2 - USB key - Save
• Plug a USB key into the front panel port.
• Save your data: results / logs / conguration.
11.1.3 - USB key - Advanced diagnostic
• Plug a USB key into the front panel port.
• Select how often the logs are saved on the USB key.
Period 1/2/6/12/24 hour(s)
• Click «Start».
• Do not unplug the USB key from the front panel.
To Next Page
Loading...
Need help?
General
