Develop ineo 4020 - Page 183

User's Guide
- 183 -
Use
To
Web Page Refresh Rate
30–300
Specify the number of seconds between Embedded Web
Server refreshes.
Note: 120 is the factory default setting.
Contact Name
Specify a contact name for the printer.
Note: The contact name will be stored on the Embedded Web
Server.
Location
Specify the location of the printer.
Note: The location will be stored on the Embedded Web
Server.
Alarms
Alarm Control
Cartridge Alarm
Set an alarm to sound when the printer requires user
intervention. When activated, Alarm Control lets you set the
number of times that the alarm sounds, while Cartridge Alarm
lets you stop printing when a cartridge-low condition occurs.
For each alarm type, select from the following options:
Off
Single
Continuous
Notes:
- Single is the factory default setting for Alarm Control.
This sounds three quick beeps.
- Off is the factory default setting for Cartridge Alarm.
This means no alarm will sound.
- Continuous repeats three beeps every 10 seconds.
Timeouts
Standby Mode
Disabled
1–240
Specify the number of minutes of inactivity before the printer
enters a lower power state.
Note: 15 is the factory default setting.