ineo+ 650/550/451 2-29
Copy Operations
2
1 Position the document to be copied.
– For details on positioning the document, refer to "Feeding the document" on page 2-26.
2 In the Basic screen, touch [Separate Scan].
– To cancel the "Separate Scan" setting, touch [Separate Scan] again to deselect it.
3 Press the [Start] key.
After the document has been scanned, the following message appears.
– If the "Separate Scan Output Method" parameter is set to "Batch Print", touch [Finish] in the
following screen, which appears while the document is scanned with the ADF, to continue to step 5.
– Load the next batch of the document, and then press the [Start] key.
– Repeat step 2 until all document pages have been scanned.
– If the document cannot be loaded into the ADF, place it on the original glass. For details on the types
of documents that can be loaded into the ADF, refer to "Original documents" on page 2-95.
– To change the scanning settings, touch [Change Setting].
To Next Page
Loading...
