D-Show Guide206
Output Channel Section
D-show Output controls consist of 8 output channel strips
with separately assignable output encoders (AOEs) and output
faders (AOFs), and a set of assignment controls for each. This
section is used to control output signals from Groups, Auxes,
Matrixes, and the PQ Monitoring system.
Master and Global Section
The Master and Global section includes controls for the Main
Busses, Monitoring, Talkback, Mute Groups, and the Solo Bus.
Meter Bridge
The Meter Bridge provides system status information and me-
tering information for the selected channel in the ACS, the se-
lected Output bus, and the Main bus.
Meter Bridge USB Port
The USB port on the Meter Bridge is a USB 1.1 port. This port
supports iLoks, USB key disks, and USB keyboards.
Main Unit Front Ports
The Main Unit includes the following front ports (Figure 16):
Front USB Port
The USB port on the front of the Main Unit is a USB 1.1 port.
This port supports iLoks, USB key disks, and USB keyboards.
Headphone Connector
The headphone connector on the front of the Main Unit is a
standard 1/4-inch stereo headphone jack. The connector is
fed by the Monitor bus.
Figure 16. Main Unit front ports (under front of unit)
Headphone connectorFront USB port