Dodge Intrepid - Page 573

(50) Remove snap ring (Fig. 68).
(51) Remove low/reverse piston belleville spring
(Fig. 69).
(52) Remove park sprag pivot retaining screw (Fig.
70).
Fig. 67 Compressor Tool in Use
1 - LOW/REVERSE CLUTCH RETURN SPRING
2 - SNAP RING (INSTALL AS SHOWN)
3 - TOOL 5058A-3
4 - TOOL 5059A
5 - SPECIAL TOOL 6057
Fig. 68 Remove Snap Ring
1 - SNAP RING OPENING MUST BE BETWEEN SPRING
LEVERS (AS SHOWN)
2 - SNAP RING PLIERS
3 - SPECIAL TOOL 5059A
Fig. 69 Low/Reverse Piston Belleville Spring
1 - LOW/REVERSE PISTON RETURN SPRING
2 - PISTON
Fig. 70 Remove Parking Sprag Pivot Retaining
Screw
1 - TRANSFER SHAFT
2 - PARKING SPRAG PIVOT RETAINING SCREW
21 - 26 TRANSAXLE LH
42LE AUTOMATIC TRANSAXLE (Continued)