Dodge Intrepid - Page 781

INSTRUMENT PANEL
TABLE OF CONTENTS
page page
CLUSTER BEZEL
REMOVAL .............................44
INSTALLATION .........................44
DASH SILENCER
REMOVAL .............................45
INSTALLATION .........................45
GLOVE BOX
REMOVAL .............................46
INSTALLATION .........................46
GLOVE BOX LATCH
REMOVAL .............................46
INSTALLATION .........................46
INSTRUMENT PANEL ASSEMBLY
REMOVAL .............................46
INSTALLATION .........................48
INSTRUMENT PANEL CENTER BEZEL
REMOVAL .............................55
INSTALLATION .........................55
INSTRUMENT PANEL END CAP
REMOVAL .............................55
INSTALLATION .........................55
INSTRUMENT PANEL SILENCER
REMOVAL .............................56
INSTALLATION .........................56
INSTRUMENT PANEL TOP COVER
REMOVAL .............................56
INSTALLATION .........................56
UPPER RIGHT TRIM BEZEL(300M)
REMOVAL .............................56
INSTALLATION .........................57
STORAGE BIN-5PASSENGER VEHICLES
REMOVAL .............................57
INSTALLATION .........................57
STORAGE BIN-6PASSENGER VEHICLES
REMOVAL .............................57
INSTALLATION .........................57
STEERING COLUMN COVER
REMOVAL .............................57
INSTALLATION .........................58
STEERING COLUMN COVER REINFORCEMENT
REMOVAL .............................58
INSTALLATION .........................58
CLUSTER BEZEL
REMOVAL
(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post
(Fig. 1).
(2) Remove the instrument panel left end cap.
(3) Remove steering column shroud cover.
(4) Tilt the steering column down into the lowest
position.
(5) Remove one screw (Concorde/300M) to cluster
bezel
(6) Remove the items to expose bezel mounting
screws. Items vary depending on model.
(7) Remove two screws over upper cluster bezel in
instrument panel brow area and all remaining
attaching screws.
(8) Using a trim stick (special tool #C-4755), gently
pry out on the instrument panel cluster bezel, discon-
nect headlamp switch connector, and remove.
INSTALLATION
(1) Connect headlamp switch connector. Place the
cluster bezel into position and snap it into place
firmly.
(2) Install the two screws over upper cluster bezel
in instrument panel brow area and all remaining
attaching screws.
Fig. 1 NEGATIVE BATTERY CABLE REMOTE
TERMINAL
1 - RIGHT STRUT TOWER
2 - AIR CLEANER INLET TUBE
3 - REMOTE TERMINAL
23 - 44 INSTRUMENT PANEL LH