130 of 152 PSS5000/TEMA/803046/05
PSS 5000 – Technical Manual
C Web Service Connections
2. Click Properties.
The
<connection name> Properties window appears. This window has 5
tabs:
•
General
• Options
• Security
• Networking
• Advanced
3. On the General tab, open the Select a device drop-down list and select Com-
munications cable between two computers (COM1)
if it is not already in the
field.
4. Click Configure.
The
Modem Configuration window appears.
5. Set up the parameters as shown below:
•
Maximum speed (bps): 38400
• Clear all check boxes
6. Click OK.
7. Select the Networking tab and set the following parameters:
• Type of dial-up server I am calling, :
PPP: Windows ...
•Select Internet Protocol (TCP/IP) check box
• Clear all remaining check boxes
8. Click OK.
The connection is now configured correctly to communicate with PSS
5000 and the
Connect <connection name> window appears.
9. Type in a user name (admin) and password (password) for the PSS 5000
and click
Connect.
The PC now uses the null modem cable and the connection configured
above to connect to the PSS 5000.
To Next Page
Loading...
Need help?
General
