22 of 152 PSS5000/TEMA/803046/05
PSS 5000 – Technical Manual
3 Configuration and Service
Local Service Panel
display
The display in the Local Service Panel provides you with information about
where you are in the menu structure, the software identification numbers, or
the current values of parameters selected in the software.
By default the Idle menu is displayed. The system returns to the Idle menu au-
tomatically if a navigation button is not pressed within the timeout period. This
menu shows the following information:
• An 8 digit number, which is the ID of the Application software.
• The current time of the PSS’s internal clock.
• Arrows that inform you which button to press to enter the W&M or Ser-
vice menus.
The Idle menu provides an entry point to both the W&M menus and the Service
menus.
Error messages on the
service panel display
The display can show error codes or refer you to the error log file. If some of
the errors are unread, then the lower line on the display tells you to look at the
log file.
The PSS 5000 has its own post-process, diagnostics program, which prevents
the program from running when serious errors occur. When this happens the
program number and the text "DEAD" are displayed together with some
codes, as shown in the example below:
When this happens, write down this information and send it to Doms Support
at the following e-mail address: support@doms.dk
The "DEAD" text and error codes remain in the display until a button is
pressed. This causes the CPU board to reset and attempt to re-start the appli-
cation, or the CPU board is powered down.
Viewing data in the Local
Service Panel display
Data stored in the PSS 5000 memory, such as Recent Transactions or Trans-
action Log, can be viewed using the local service panel display. However, be-
cause of the size of the display, it is important to understand how the data ap-
Idle menu
(APPL version and time)
To Next Page
Loading...
Need help?
General
