98 of 152 PSS5000/TEMA/803046/05
PSS 5000 – Technical Manual
8 Diagnostics (Menu 5)
Note: Each file can be named with an optional file name (default is peepfile)
and with an extension letter followed by a 2 digit sequence number
(from 00 to 99).
When the Java Peep Applet is started via the systems home page, it is possible
to start the peeper facility and collect peeper trace files (peep files) from the
PSS 5000 system and store them on the connected PC.
The Peeper Applet has a digital signature from VeriSign. This proves that it is
an authentic Doms Java Applet. When the Applet is activated you are prompt-
ed to accept the digital signature. This ensures that the peep files are written to
the hard disk. If the signature is not accepted, then the peep applet doesn’t run.
To start peep with web
service pages
This procedure describes how to use the Service Menu in the web browser to
start the peeper.
1. Select 5 Diagnostics → 5.4 Peep.
The
Peep Setup page appears.
2. Select the ports where the peeper is to be active.
Note: Port 41 is always selected. In addition to this, the following ports are also
selected:
– ports selected the last time the page was open
– ports where the PSS 5000 has received more than 100 counters.
3. Click START PEEP.
To Next Page
Loading...
Need help?
General
