PPP (Point-to-Point Protocol)
PPP (Point-to-Point Protocol)
This applies if the IPv4 access mode is PPPoE, and the IPv4 ISP also provides an IPv6 address.
To use IPv6 PPP, you just need to choose the Connection Type to "PPP", no other setting is
required.
TSPC (Tunnel Setup Protocol Client)
TSPC (Tunnel Setup Protocol Client)
In this mode, the IPv6 connectivity is provided by a tunnel broker on the IPv4 Internet
through a tunnel set up by Tunnel Setup Protocol (TSP). To use TSPC, you'll need to sign up
for a tunnel broker service and get a username and password first, then, configure the
router as follows:
1. Set Connection Type to TSPC.
2. Enter the Username and Password registered at the TSP server.
3. Enter the IP or Domain Name of the TSPC server for Tunnel Broker.
　 　
Vigor2762 Series User’s Guide
To Next Page
Loading...
Need help?
General
