-d [enable] Enable / disable the function of DND (Do Not Disturb)
0 – disable
1 - enable
-s [id] Indicate DND schedule.
Id - s1, s2, s3, s4 (max. 4 schedule)
-h [enable] Enable / disable the function of calling line identification
restriction (CLIR).
0 – disable
1 - enable
-u [mode] Set CLIR mode.
0 - means “draft-ietf-sip-privacy”
1 – means “rfc 3323/3325)”
-z [enable] Enable / disable playing dial tone when registered on sip server.
0 – disable
1 - enable
-n [enable] Enable / disable session timer.
0 – disable
1 - enable
-m [sec] Set the value for session timer (unit: sec).
-R [min,max] Set the flash hook time range 100~2000 (unit: ms).
-8 [enable] Enable or disable T.38 fax relay feature.
0 – disable
1 - enable
-v View current settings.
voip sip misc - Allows users to set miscellaneous settings for the device.
-c [enable] Enable compact header to shorten the packet (0: disable, 1:
enable).
-s [enable] Change “#” into digit number.
0 - disable
1 - enable
-e [enable] Enable Europe style flash hook operation mode.
0 - disable
1 - enable
-h [enable] Enable/disable call hold mode based on protocol RFC2543 (0:
disable, 1:enable).
-i [enable] Enable CODEC change without Re-INVITE.
0 - disable
1 - enable
-p [enable] Enable PRACK message.
0 – Not support PRACK.
1 – Support PRACK.
-P [enable] Enable IP Call.
0 – Disable IP call.
1 – Enable IP call.
-H [enable] SIP INFO packet will be sent out when encounting hook flash event.
To Next Page
Loading...
