Draytek Vigor2860 - Page 879

Vigor2860 Series User’s Guide
865
0 – disable
1 – stun
2 – manual
3 - nortel
-F [mode] Set call forwarding mode.
0 – disable
1 – always
2 – busy
3 - no answer
4 - busy or no answer
-u [url] Set SIP URL for call forwarding (max. 63 characters).
-t [sec] Set call forwarding timer. For example,
voip sip acc 1 –t 30
-g [port] Set the ring port for incoming call. For example,
Port - r1 means FXS1; r2 means FXS2.
-z [pattern] Set account ring pattern (1 ~ 6).
-i [enable] Remove all bindings while they are un-registered. 0 means Disable;
and 1 means Enable.
-B <enable> Enable / disable the function of Broadsoft Call Control.
0 – disable
1 - enable
-S [idx] Enable and use alias IP to register.
idx - 1 to 31. If 0 is used, such function will be disabled.
-k [num1 num2...] Set backup wan list (first wan, second wan...).
range: 1 to 4.
-v View current status for account settings.
Voip sip calllog Display current status for SIP call log.
voip sip ep
n The index number of the VoIP settings.
n – 1, 2.
-o [acc] Available dial out account (1 ~ 12).
-L [url] Set SIP URL (max. 63 characters) for hot line.
-l [enable] Enable / disable the function of hot line.
0 – disable
1 - enable
-W [enable] Enable / disable the function of warm line.
0 – disable
1 - enable
-w [enable] Enable / disable the function of call waiting enable.
0 – disable
1 - enable
-E [enable] Enable / disable the function of call waiting enable but only remind
one time.
0 – disable
1 - enable
-x <enable> Enable / disable the function of call transfer.
0 – disable
1 - enable