Draytek Vigor2860 - Page 888

Vigor2860 Series User’s Guide
874
ometh It means IPSec Security Method.
“ometh=ah/” means AH.
“ometh=espd/espda/” means ESP DES without/with
Authentication.
“ometh=esp3/esp3a/” means ESP 3DES without/with
Authentication.
“ometh=espa/espaa” means ESP AES without/with Authentication.
sch It means Index(1-15) in Schedule Setup.
sch=1,3,5,7 Set schedule 1->3->5->7
rcallb It means Require Remote to Callback.
“rcallb=on/off” means to enable/disable Set Require Remote to
Callback.
ikeid It means IKE Local ID.
“ikeid=vigor” means Set Local ID = vigor.
For Dial-In Settings
itype It means Allowed Dial-In Type. Available settings include:
“itype=t” means PPTP.
“itype=s” means IPSec.
“itype=L1”means L2TP (None).
“itype=L1” means L2TP(Nice to Have).
“itype=l2” means L2TP(Must).
peer It means specify Peer VPN Server IP for Remote VPN Gateway.
Type “203.12.23.48” means to allow VPN dial-in with IP address of
203.12.23.48.
Type “off” means any remote IP is allowed to dial in.
peerid It means the peer ID for Remote VPN Gateway.
Type “draytek” means the word is used as local ID.
iname It means Dial-in Username.
“iname=admin” means to set username as “admin”.
ipwd It means Dial-in Password.
“ipwd=1234” means to set password as “1234”.
ivj It means VJ Compression.
“ivj=on/off” means to enable /disable VJ Compression.
ikey It means IKE Pre-Shared Key.
“ikey=abcd” means to set IKE Pre-Shared Key = abcd.
imeth It means IPSec Security Method
“imeth=h” means “Allow AH”.
“imeth=d” means “Allow DES”.
“imeth=3” means “Allow 3DES”.
“imeth=a” means “Allow AES.
For TCP/IP Settings
mywip It means My WAN IP.
“mywip=1.2.3.4” means to set My WAN IP as “1.2.3.4”.
rgip It means Remote Gateway IP.
“rgip=1.2.3.4” means to set Remote Gateway IP as “1.2.3.4”.
rnip It means Remote Network IP.
“rnip=1.2.3.0” means to set Remote Network IP as “1.2.3.0”.
rnmask It means Remote Network Mask.