103
2
PC Controller Setting
4
Programming a JOB for DC-646 Via Computer (PC Controller)
REFERENCE
● Standard Size
Click
Standard Size
and select from the
Paper Size
box.
Then click
NEXT
.
You can set
Custom Size
in the following range.
Width:
210 to 370 mm
Length: 210 to 999.9 mm
Paper Size
● Custom Size
Select
Custom Size
when using documents of other
size than the standard size.
Enter a value of document width and length and click
NEXT
.
REG. Mark
Click
REG. Mark enable
to use the REG mark reading
function.
Enter the distance from the right edge of the document
to the side mark in the
Side Mark
box, then click
NEXT
.
Enter the distance from the lead edge of the document
to the lead mark in the
Lead Mark
box, then click
NEXT
.
When not using this function, click
REG. Mark disable
,
then click
NEXT
.
Enter a JOB name in the
JOB Name
box and click
NEXT
.
You can enter up to 30 characters.
Usable characters;
• Alphabetical letters (A to Z, a to z)
• Numeric characters
• Symbols
REFERENCE
Finished size
Enter a value of the fi nished document width in the
Width
box and click
NEXT
.
Then enter a value of the fi nished document length in
the
Length
box and click
NEXT
.
To Next Page
Loading...
