104
PC Controller Setting
Gutter Slits
Set the gutter slit width (width between each card)
(vertical cutting).
After entering one numerical value, click
NEXT
.
Then enter the next value. Set all the gutter slit widths.
Enter
0
if there is no gutter slit between cards.
Trim
Set the margins of a document.
Enter a value of the lead margin in the
Lead Trim
box
and click
NEXT
.
Then enter a value of the right margin in the
Side Trim
R
box and click
NEXT
.
Enter
0
for no trim.
REFERENCE
e.g. If you have selected
Slitter Module
in the
Slot 3 [L/
R]
box and
Slot 4 [L/R]
box, you can enter up to six
slit positions.
If you entered
5
in the
Crosswise
box of
Cards per
document
as shown in the fi gure on the right, the
DC-646 cannot process gutter slit and
Cannot enter
Gutter Slits dialog
appears. Click
OK
.
Cards per document
Enter the number of cards in the
Crosswise
box and
click
NEXT
.
Then enter the number of cards in the
Lengthwise
box
and click
NEXT
.
Gutter Cuts
Set the gutter cut
width (horizontal cutting).
After entering one numerical value, click
NEXT
.
Then enter the next value.
Set all the gutter cut
widths.
Enter
0
if there is no gutter cut between cards.
To Next Page
Loading...
