Above Ground Model 200iX/250iX Motorcycle Dynamometer Installation Guide
A-2
INSTALLATION
Use the table below to determine the catalog number, drill bit size, minimum hole
depth, and setting tool catalog number.
Use the following instructions to install the Red Head anchors.
1 Drill the hole in the concrete the same outside diameter as the anchor being used
to any depth exceeding minimum embedment.
Figure A-1: Red Head Anchor—Drill the Hole
2 Insert the anchor.
Figure A-2: Red Head Anchor—Insert the Anchor
catalog number drill bit size
minimum hole
depth
setting tool
catalog number
Carbon Steel
RM-38/RL-38 (9.5
mm)
1/2-inch 1 5/8-inch (41.2 mm) RT-138
To Next Page
Loading...
Need help?
General