Eaton easy500, easy700

4 Wiring  with
4.7 Text Display
Operating instructions 05/10 MN05013003Z-EN www.eaton.com 109
4.7 Text Display
easy500 and easy700 can display up to 16 user-defined texts. These texts
can be triggered by the actual values of function relays such as timing relays,
counters, operating hours counters, analog value comparators, date, time or
scaled analog values. Set values of timer relays, counters, hours run counters
and analog value comparators can be altered during the display of the texts.
The texts are saved in the easySoft file or on the EASY-M-32K memory card
for easy500 and easy700.
4.7.1 Wiring a text display
You integrate a text display into your circuit in the form of a contact and coil.
The coils and contacts have the following meanings:
The text display does not have a parameter display in the PARAMETER
menu.
4.7.2 Retention
The texts D1 to D8 can be operated with retentive actual values (contacts).
Text display D1...D16 (Display)
Boolean inputs/outputs Parameters
Contact Coil Input value Output value
D.. State of the coil
D.. 1 shows the
text in the
display
OP1 Actual value for line 2 - -
- - - - OP2 Actual value for line 3 - -
￫
The text display can only be edited with the easySoft-Basic or
easySoft-Pro from Version 6.xx.
￫
Compatibility with easy600
If you wish to load an existing easy600 circuit diagram, the
available text display functions are retained. The text display in
easy500 and easy700 devices operates in the same way as in
an easy600 device.
I5-------ÄD2
I6-------ÄD3
D2u------ÄT5
D3k
Contact Coil
D1 - D16 Coil of the corresponding text display is triggered
Ä, Å, è, ^, ä, S, R
D1 - D16
If a coil is triggered, the text is shown in the display.