4 Wiring with
4.2 Working with contacts and relays
Operating instructions 05/10 MN05013003Z-EN www.eaton.com 71
4.2.5 Checking the circuit diagram
easy contains a built-in measuring device enabling you to monitor the
switching states of contacts and relay coils during operation.
▶ Complete the small parallel connection and switch easy to RUN mode via
the main menu.
▶ Return to the circuit diagram display.
You are now unable to edit the circuit diagram.
The circuit diagram display performs two functions depending on the mode:
• STOP: Creation of the circuit diagram
• RUN: Power flow display
▶ Switch on I3.
In the power flow display, energized connections are thicker than non-
energized connections.
You can follow energized connections across all rungs by scrolling the display
up and down.
￫
If you switch to the circuit diagram display and are unable to
modify a circuit diagram, first check whether easy is in STOP
mode.
￫
The power flow display will not show signal fluctuations in the
millisecond range. This is due to the inherent delay factor of
LCD displays.
To Next Page
Loading...
