4 Wiring with
4.8 Weekly timer
Operating instructions 05/10 MN05013003Z-EN www.eaton.com 113
4.8 Weekly timer
easy500 and easy700 with type suffix EASY…-…-.C. are provided with a real-
time clock. The time switches can only be used properly in these devices.
easy offers eight weekly timers
Ö1 to Ö8 for up to 32 switch times.
Each time switch has four channels which you can use to set four on and off
times. The channels are set via the parameter display.
The timer has a back-up battery. This means that it will continue to run in the
event of a power failure, although the time switch relays will not switch. The
contacts are kept open when de-energized. Information on the battery back-
up time are provided on (￫ Chapter 8 "Appendix“, page 211).
A weekly timer can be integrated into your circuit in the form of a contact.
￫
The procedure for setting the time, (￫ section “5.4 Setting
date and time”, page 170).
Weekly timer Ö1…Ö8 (Week)
Boolean inputs/outputs Parameters
Contact Coil Input value Output value
Ö
1 if on time is reached - - - - - -
￫
Compatibility with easy400 and easy600
If you wish to load an existing easy400 or easy600 circuit
diagram, the existing weekly timer functions are retained. The
weekly timer in easy500 devices and easy700 devices operates
in the same way as in an easy400 device, easy600.
Contact Coil
Ö1 - Ö8 Contact of the weekly timer
To Next Page
Loading...
