5 settings
5.1 Password protection
164 Operating instructions 05/10 MN05013003Z-EN www.eaton.com
5.1.1 Password setup
A password can be set up via the System menu in either RUN or STOP
mode. You cannot change to the System menu if a password is already
activated.
▶ Press DEL and ALT to call up the System menu.
▶ Select the menu option SECURITY… to enter the password.
▶ Press the OK button and move to the PASSWORD… menu.
▶ Press OK again to enter the Password entry mode.
If no password has been entered, easy changes directly to the password
display and displays for XXXX characters: No password present.
▶ Press OK, four zeros will appear
▶ Set the password using the cursor buttons:
•
úí select position in the password,
•
ÍÚ Select a value between 0 and 9.
▶ Save the new password by pressing OK.
Use OK to exit the password display and proceed with ESC and Ú to the
RANGE… menu.
The scope of the password has not yet been defined. The password is now
valid but not yet activated.
5.1.2 Selecting the scope of the password
▶ Press the OK button.
▶ Select the function or the menu to be protected.
▶ Press the OK button in order to protect the function or menu
(tick = protected).
• CIRCUIT DIAG: The password is effective on the program with circuit
diagram and non-enabled function relays.
• PARAMETER: The PARAMETER menu is protected.
• CLOCK: Date and time are protected with the password.
• OPERATING MODE: The toggling of the RUN or STOP operating mode is
protected.
• INTERFACE: The interface is blocked for access with easySoft
(-Basic, -Pro).
• DELETE FUNCT: The question DELETE PROG? will appear on the device
after four incorrect password entries have been made. This prompt is not
displayed if selected. However, it is no longer possible to make changes
in protected areas if you forget the password.
CIRCUIT DIAGåÆ
PARAMETER
CLOCK
OPRTNG MODE æ
INTERFACE
DELETE FUNCT
￫
Standard protection encompasses the programs and circuit
diagram.
At least one function or menu must be protected.
To Next Page
Loading...
