5 settings
5.7 Star tup behavior
178 Operating instructions 05/10 MN05013003Z-EN www.eaton.com
5.6.2 Function of the P buttons
The P buttons are only active in the Status display. In this display you can use
the P buttons to activate inputs in your circuit diagram.
5.6.3 Deactivating the P buttons
▶ Select P BUTTONS å and press OK.
easy changes the display to
P BUTTONS and the P buttons are deactivated.
5.7 Startup behavior
The startup behavior is an important aid during the commissioning phase.
The circuit diagram which easy contains is not yet fully wired up, or the
system or machine is in a state which easy is not permitted to control. The
outputs should not be controlled when easy is switched on.
5.7.1 Setting the startup behavior
Requirement: easy must contain a valid circuit diagram.
Switch to the system menu.
Specify the operating mode which easy must use when the power supply is
switched on.
￫
If a text is displayed, the P buttons only function if a value entry
is not carried out.
￫
If you delete a circuit diagram in easy, the P buttons are
automatically deactivated. If all circuit diagrams are loaded from
the memory card or easySoft, the set state is transferred.
￫
The easy models without a display can only be started in RUN
mode.
￫
Default settings:
RUN mode is activated.
￫
If easy is password-protected, the System menu can only be
accessed after easy has first been “unlocked” (￫ Section
"5.1.4 unlocking“, from page 165).
To Next Page
Loading...
