5 settings
5.6 Activating and deactivating the P buttons
Operating instructions 05/10 MN05013003Z-EN www.eaton.com 177
5.5.2 Deactivating debounce (input delay)
If easy is showing DEBOUNCE in the display, this means that Debounce mode
has already been deactivated.
▶ Otherwise select
DEBOUNCE å and press OK.
If Debounce mode is deactivated the display will show
DEBOUNCE.
5.6 Activating and deactivating the P buttons
Even though the cursor buttons (P buttons) have been set as pushbutton
actuator inputs in the circuit diagram, this function is not activated
automatically. This prevents any unauthorized use of the cursor buttons. The
P buttons can be activated in the System menu.
The P buttons are activated and deactivated via the P BUTTONS menu.
▶ Press DEL and ALT to call up the System menu.
▶ Select the SYSTEM menu.
▶ Move the cursor to the P BUTTONS menu.
5.6.1 Activating P buttons
If easy is displaying P BUTTONS å, this means that the P buttons are active.
▶ Otherwise select P BUTTONS and press OK.
easy changes the display to
P BUTTONS å and the P buttons are activated.
▶ Return to the status display using ESC.
￫
How easy input and output signals are processed internally is
explained in (￫ Section "6.2 Delay times for inputs and
outputs“, from page 189).
￫
If easy is password-protected you cannot open the System
menu until you have “unlocked” it.
￫
Default settings:
The P buttons are not activated.
DEBOUNCE åÆ
P BUTTONS
RUN MODE
CARD MODE æ
DEBOUNCE åÆ
P BUTTONS å
RUN MODE
CARD MODE æ
To Next Page
Loading...
