2 Installation
2.1 Mounting
26 Operating instructions 05/10 MN05013003Z-EN www.eaton.com
2.1 Mounting
Install the easy in a control cabinet, service distribution board or in an
enclosure so that the power supply and terminal connections cannot be
touched accidentally during operation.
Clip easy onto a DIN EN 50022 top-hat rail or fix easy in place using fixing
brackets. easy can be mounted vertically or horizontally.
For ease of wiring, leave a gap of at least 30 mm between easy terminals
and the wall or adjacent devices.
Figure 4: Clearances to easy
2.1.1 Mounting on top-hat rail
▶ Hook easy to the top edge of the top-hat rail and hinge into place while
pressing down slightly. Press down lightly on both the device and the
top-hat rail until the unit snaps over the lower edge of the top-hat rail.
Easy will clip into place and will be secured by the built-in spring mechanism.
▶ Check that the device is seated firmly.
The device is mounted vertically on a top-hat rail in the same way.
￫
When using easy with expansion units, connect the expansion
concerned before mounting (￫ section “2.2 Connecting the
expansion device”, page 28).
To Next Page
Loading...
