Eaton easy500, easy700

6  Internal
6.9  with a remote display and operator unit
202 Operating instructions 05/10 MN05013003Z-EN www.eaton.com
6.9  with a remote display and operator unit
easy500/700 devices can be operated with a remote display and operator
unit. In this configuration, all the display information is transferred via the
serial multi-function interface.
This has the advantage that easy can be operated remotely. The texts in easy
are backlit and displayed on the front of the operator or control panel in twice
the size. The display/operating unit provides protection to IP65.
If a display/operating unit with a keypad is used, easy can be programmed
and assigned parameters from “outside”.
The MFD-80 (IP65 display unit), MFD-80-B (IP65 display/operating unit) with
the MFD-CP4-500 power supply/communication unit are currently available
for use as stand-alone display/operating units.
6.10 Device version
Every easy has the device version number printed on the left of the device
housing. The device version is indicated by the first two digits of the device
number.
Figure 102: Example of device version
This device is of device version 01.
The device version provides useful service information about the hardware
version and the version of the operating system. The device version is
important for selecting the correct control relay for EASY-SOFT-BASIC.
￫
Card mode operation is not possible when using a stand-alone
display/operating unit. The interface can only be used once.
￫
The MFD-CP4 communication unit establishes permanent
communication with the easy control relay. This increases
easy's cycle time, and must be taken into account during
engineering.
DC 20.4 …28.8 V
3 W
01-900000042