5 settings
5.7 Star tup behavior
Operating instructions 05/10 MN05013003Z-EN www.eaton.com 179
5.7.1.1 Activating RUN mode
If easy is displaying RUN MODE å, easy switches to RUN mode when the
power supply is switched on.
▶ Otherwise select RUN MODE and press OK.
RUN mode is activated.
▶ Return to the status display using ESC.
5.7.1.2 Deactivating RUN mode
▶ Select RUN MODE å and press OK.
The RUN mode function is deactivated.
The default setting for easy is for
RUN MODE å to be displayed. In other
words, easy starts in RUN mode when the power is switched on.
Table 33: Startup behavior
5.7.2 Behavior when the circuit diagram is deleted
The setting for the startup behavior is an easy device function. When the
circuit diagram is deleted this does not result in the loss of the setting
selected.
5.7.3 Behavior during upload/download to card or PC
When a valid circuit diagram is transferred from easy to a memory card or the
PC or vice versa, the setting is still retained.
5.7.4 Possible Faults
easy will not start in RUN mode:
• easy does not contain a program.
• You have put easy in STOP mode (RUN MODE menu).
DEBOUNCE åÆ
P BUTTONS
RUN MODE å
CARD MODE æ
DEBOUNCE åÆ
P BUTTONS
RUN MODE å
CARD MODE æ
Startup behavior Menu displayed Status of easy after startup
easy starts in STOP mode RUN MODE easy is in STOP mode
easy starts in RUN mode
RUN MODE å easy is in RUN mode
￫
The easy models without a display can only be started in RUN
mode.
To Next Page
Loading...
