5 settings
5.9 Retention (non-volatile data storage)
184 Operating instructions 05/10 MN05013003Z-EN www.eaton.com
5.9.5.1 Changing the operating mode
If you change from RUN to STOP and then back to RUN, the actual values of
the retentive data will be retained.
5.9.5.2 Modifying the circuit diagram
If a modification is made to the easy circuit diagram, the actual values will be
retained.
5.9.6 Changing the startup behavior in the SYSTEM menu
The retentive actual values in easy will be retained irrespective of the RUN
MODE or STOP MODE settings.
CAUTION
Even if the markers and function relays that were retentive are
deleted from the circuit diagram, the retentive actual values
remain when changing from STOP to RUN, and when switching
the device off and on. Should these relays be used again in the
circuit diagram, they will still have their former actual values.
To Next Page
Loading...
