5 settings
5.10 Displaying device information
Operating instructions 05/10 MN05013003Z-EN www.eaton.com 185
5.10 Displaying device information
Device information is provided for service tasks and for determining the
capability of the device concerned.
This function is only available with easy devices featuring a display.
Exception:
• Terminal mode with MFD-CP4 (see AWB2528-1548).
• MFD-CP8-… (see AWB2528-1480).
Easy allows you to show the following device information:
• AC, AB (AC voltage) or DA, DC (DC voltage),
• T (transistor output) or R (relay output)
• C (clock provided)
• LCD (display provided)
• OS: 1.10.204 (operating system version)
• CRC: 25825 (Checksum of the operating system is only displayed in
STOP mode).
• Program name if this was assigned in easySoft.
▶ Switch to the main menu.
▶ Select the main menu.
▶ Select the INFO.. menu with the cursor button Ú.
▶ Press the OK button.
This will display all device information.
Press ESC to exit the display.
￫
The device information is always available. The password does
not prevent access.
PROGRAM... Æ
STOP å RUN
PARAMETERS..
INFO... æ
SET CLOCK..
DC TC LCD
OS: 1.00.027
CRC: 02752
PROGRAM_0815
To Next Page
Loading...
