7 What Happens If …?
7.3 Event
Operating instructions 05/10 MN05013003Z-EN www.eaton.com 205
7.3 Event
Event Explanation Remedy
The actual values are not
being stored retentively.
Retention has not been switched on. Switch on retention in the
SYSTEM menu.
The RETENTION… menu
is not displayed in the
SYSTEM menu.
easy is in RUN mode Select STOP mode
The SYSTEM menu is not
displayed.
This easy model does not have this menu. Exchange easy if you need
retention
easy starts only in
operating mode STOP
No circuit diagram in easy Load, input circuit diagram
Startup behavior is set to the function "Startup
in operating mode STOP".
Set the startup behavior in the
SYSTEM menu.
LCD display showing
nothing.
No power supply Switch on the power supply
easy is faulty Press the OK button. If no menu
appears, replace the easy.
Text displayed with too many spaces Enter text or do not select
GW flashes on the Status
display
EASY200-EASY bus coupler detected without I/
O expansion
Connect I/O expansion to
external easyLink
To Next Page
Loading...
