3 Placing into operation
3.4 Creating your first circuit diagram
58 Operating instructions 05/10 MN05013003Z-EN www.eaton.com
3.4.5 Deleting the circuit diagram
▶ Switch easy to STOP mode.
The display shows
STOP å RUN.
▶ Use
PROGRAM... to switch from the main menu to the next menu level.
▶ Select
DELETE PROG.
easy will display the prompt
DELETE?.
▶ Press OK to delete the program or ESC to cancel.
Press ESC to return to the Status display.
3.4.6 Fast circuit diagram entry
You can create a circuit diagram in several ways: The first option is to enter
the elements in the circuit and then to wire all the elements together. The
other option is to use the enhanced operator guidance of easy and create the
circuit diagram in one go, from the first contact through to the last coil.
If you use the first option, you will have to select some of the elements in
order to create and connect up your circuit diagram.
The second, faster option is what you learned in the example. In this case
you create the entire rung from left to right.
￫
easy must be in STOP mode in order to extend, delete or
modify the circuit diagram.
To Next Page
Loading...
