Eaton easy500, easy700

4 Wiring  with
4.3 Function Relays
78 Operating instructions 05/10 MN05013003Z-EN www.eaton.com
4.3.1 Example: with function relay timer and counter relay
A warning light flashes when the counter reaches 10. The example shows
function relays C1 and T1. The S1 pushbutton actuator is used for the count
signal. The S2 pushbutton actuator resets counter P1.
Figure 46: Hardwiring with relays
The wiring of the easy relay looks as follows.
Figure 47: easy wiring and circuit diagram
The counter P1 is called C1 in easy.
The timing relay K1T is called T1 in easy.
▶ Complete the circuit diagram up to
CC1.
CC1 is the count coil of the counter 1 function relay.
▶ Move the cursor onto the
1 of CC1 and press OK.
The parameter set for the counter is displayed.
L01–
P1
P1
K1T
K1T
C
R
E1
S1
S2
L01+
2s
Zähler
Wert 10
I5-------CC1
I6-------RC1
C1-------TT1
T1-------ÄQ1
1
2
E1
L01–
S2
L01+
L01–
+24 V
0 V I5 I6
S1
Q 1
I5-------CC1
￫
Press OK to call up the easy parameter display.