Eaton easy500, easy700

4 Wiring  with
4.7 Text Display
112 Operating instructions 05/10 MN05013003Z-EN www.eaton.com
The example shows the following.
The setpoint of timing relay T1 is to be changed from 12 minutes to 15
minutes.
• Line 2: setpoint of timing relay T1, can be edited.
• Line 3: actual value of timing relay T1.
The text is displayed.
▶ Pressing the ALT button will cause the cursor to jump to the first editable
value.
In this Selection mode you can use the cursor buttons
ÍÚ to jump from one
editable constant to another.
▶ Press the OK button, the cursor will jump to the highest digit of the
constant to be modified.
In this Entry mode, you use the
ÍÚ cursor buttons to change the value. The
cursor buttons
úí are used to move from digit to digit inside the constant.
Use the OK button to accept the modified value. Use the ESC button to
abort the entry and leave the previous value.
▶ Pressing the OK button causes the cursor to return to Selection mode.
The modified value is accepted.
Press the ESC button to leave Entry mode.
Line 1
Line 2, setpoint can be edited
Line 3, setpoint can be edited
Line 4
￫
The appropriate text function block in the display must be
available in order to modify a setpoint.
The setpoint must be a constant.
￫
During value entry, the text is retained statically on the display.
Any actual values are refreshed.
RUNTIME M:S
T1 :012:46
C1 :0355 ST
PRODUCED
STIR M:S
S : 012:00
ACT:008:33
BREAD ROLLS
STIR M:S
S : 012:00
ACT:008:33
BREAD ROLLS
STIR M:S
S: 012:00
ACT:008:33
BREAD ROLLS
STIR M:S
S : 015:00
ACT:008:34
BREAD ROLLS
STIR M:S
S : 015:00
ACT:008:34
BREAD ROLLS
STIR M:S
S : 015:00
ACT:008:34
BREAD ROLLS