3 Placing into operation
3.4 Creating your first circuit diagram
56 Operating instructions 05/10 MN05013003Z-EN www.eaton.com
The wiring arrow works between contacts and relays. When you move the
arrow onto a contact or relay coil, it changes back to the cursor and can be
reactivated if required.
▶ Press ALT to wire the cursor from
I2 through to the coil field.
The cursor changes into a flashing wiring arrow and automatically jumps to
the next logical wiring position.
▶ Press the cursor button
í. Contact I2 will be connected up to the coil
field.
▶ Press the cursor button
í once more.
The cursor will move to the coil field.
▶ Press OK.
easy will insert relay coil
Q1. The specified coil function Ä and the output relay
Q1 are correct and do not have to be changed.
Your first working easy circuit diagram now looks like this:
Press ESC to leave the circuit diagram display.
The adjacent menu will appear.
▶ Press OK.
The circuit diagram is now automatically saved. CANCEL exits the circuit
diagram. Changes that have been made to the circuit diagram are not saved.
Once you have connected pushbutton actuators S1 and S2, you can test your
circuit diagram straight away.
￫
easy automatically wires adjacent contacts in a rung up to the
coil.
I1-I2l
êê êê êê êêê
êê êê êê êêê
êê êê êê êêê
￫
You can use DEL to erase a connection at the cursor or arrow
position. Where connections intersect, the vertical connections
are deleted first, then, if you press DEL again, the horizontal
connections are deleted.
￫
easy saves all the necessary circuit diagram and program data
retentively in the internal data memory.
To Next Page
Loading...
