7 Pilot devices M22-SWD…
7.2 M22-SWD front mount
SmartWire-DT module IP20 01/20 MN05006001Z-EN www.eaton.com 157
7.2.2.2 M22-SWD-K22
This function element replaces multiple combinations of the previous contact
elements M22-K10/K01. It provides two changeover contacts, by means of
which control switches can be operator controlled with up to three-position
indication.
7.2.2.3 M22-SWD-LED…(W/B/G/R)
This function element is used in combination with the indicator lights M22-
L.... White, blue, green and red are available as colors.
7.2.2.4 M22-SWD-LED(C)-RGB
This function element can be used in combination with the indicator lights
M22-L.... In order for the multiple colors to be as visible as possible, how-
ever, it should be combined with M22-L-T.
7.2.2.5 M22-SWD-K11LED-(W/B/G/R)
This function element contains a changeover contact and an LED in the
colours white, blue, green and red.
The function element replaces previous combinations of a contact element
M22-K01 or -K10 and an M22 LED element. It is used in combination with
luminous pushbuttons or selector buttons.
7.2.2.6 M22-SWD-K22LED…(W/B/G/R)
This function element contains two changeover contacts and an LED in the
colours white, blue, green and red.
The function element replaces previous combinations consisting of several
contact elements M22-K01 or -K10 and an M22 LED element. It is used in
combination with luminous 3-position selector switches.
All combination options for M22 front elements with SmartWire-DT function
elements for front mount are listed in the following table.
Figure 58: SmartWire-DT:Function elements
ï¿«
The adapter M22-SWD-A4, which can then accommodate two
M22-SWD-K22 function elements, is used for 4-position contact
polling (e.g. joystick M22S-WJ4) instead of the adapter M22-A4.
To Next Page
Loading...
Need help?
General
