7 Pilot devices M22-SWD…
7.2 M22-SWD front mount
168 SmartWire-DT module IP20 01/20 MN05006001Z-EN www.eaton.com
Profile 2 – Index
1 input byte, 2 output bytes
The index can be used to select one of the fixed, defined colors in ROM. In
addition, the index can be used to select one of the colors from the color
table created with SWD-Assist. This color table cannot be saved, and is not
part of the project. For more information, please refer to the color table
￫ Section “13.4.2 Color table profile 2...5”, page 257.
Outputs
Byte 0:
The LED is switched on and off with bit 0.
By changing the content of bits 5 to 7, the brightness can be reduced to any
of seven settings.
Table 36: Brightness setting
By changing the content of bits 3 to 4, the LED's flashing frequency can be
defined. If both bits have a state of "0", the LED will not flash even if a mark-
to-space ratio has been set.
Table 37: Flashing frequency settings
By changing the content of bits 1 to 2, the mark-to-space ratio for LED flash-
ing can be defined. If both bits have a state of "0", there will be no flashing
even if a flashing frequency has been set.
76543210
Brightness ?Frequency Flashing LED
on/off
Bit 7 Bit 6 Bit 5
0 0 0 Full brightness
0 0 1 First dimming setting
---…
1 1 1 Seventh dimming setting
￫
Please note that when using mixed colors, there may be color
deviations in the last two dimming settings.
Bit 4 Bit 3
0 0 No flashing
01 1 Hz
1 0 0.5 Hz
11 2 Hz
To Next Page
Loading...
