7 Pilot devices M22-SWD…
7.2 M22-SWD front mount
SmartWire-DT module IP20 01/20 MN05006001Z-EN www.eaton.com 175
Table 47: Flashing mark-to-space ratio settings
Byte 1:
The color is selected with the index in the color table. For more information,
please refer to the color table ￫ Section “13.4.1 Color table profile 1”, page
257.
If the index is set to a value of 255, bytes 2 to 4 will be evaluated for the color
selection.
Byte 2:
Color selection with red component of 0 to 255 in RGB color space.
Byte 3:
Color selection with green component of 0 to 255 in RGB color space.
Byte 4:
Color selection with blue component of 0 to 255 in RGB color space.
Diagnostics
In the event of a diagnosis the module reports the following error causes (0
is set for bit 4 in the input byte):
Bit 2 Bit 1 Mark-to-space ratio as a
percentage of the total signal
0 0 No flashing
0 1 50 / 50
1 0 25 / 75
1 1 75 / 25
76543210
Index
76543210
Red color component
76543210
Green color component
76543210
Blue color component
To Next Page
Loading...
