WaveRIDER 55
4.3.5.4 Change Slope Calculator
Positive and negative slope profile parameter calculator allows the user to calculate
straight line slopes between any two temperatures. (Default to liquidous and liquidous to
peak).
If the process changes or an operator wishes to perform test experiments, these
settings can be changed by clicking a parameter column header on the Profile
worksheet.
Figure 4- 26: Modify Summary Stat Settings
To Change Slope Calculator:
1) Select the Profile worksheet.
2) Select the Summary Stats tab.
3) Click a Peak Slope column header.
4) Change the desired settings and select the OK command to accept.
5) Once the new settings have been accepted, the software prompts the user to
decide if these new settings should be applied to future data run profiles.
To Next Page
Loading...
Need help?
General
