Insert the terminal until you hear a click. Take care to only insert the terminal far enough to click.
If the terminal is inserted too far (until it touches the front of the red terminal lock) the lock will be
unable to return to its locked position.
After all terminals have been inserted, push the red terminal lock back to its locked position.
If excessive resistance is encountered, check to ensure that no terminals are inserted too far
forward.
In order to remove a terminal, move the red terminal lock to the halfway position as described
before. Grasp the wire near the connector, and rotate it left and right over a half turn each way to
release the locking tabs, then pull the terminal out of the connector housing.
A video showing the proper assembly and disassembly of this connector can be found here:
https://www.youtube.com/watch?v=uXTkm_XV2OY
Page 10/137
To Next Page
Loading...
General