– Min show time defines the minimum amount of time in seconds that an alarm will be
shown. An alarm will be visible during this time even if the alarm condition is no longer met.
– Retrigger time defines the minimum time before an alarm will be shown again.
4. Acknowledge
After reading an alarm message, the driver may confirm it (the Allow acknowledge option). The
alarm will disappear and the threshold value will shift by a predefined Step.
In the Buttons section of the Configuration pane you can
define one or two alternative buttons for acknowledging an
alarm.
5. Global settings
There may be a situation when two alarms appear
simultaneously. Such situation can be handled in two ways,
depending on the settings of the Multiple alarms mode
a) Cycle active alarms will cause active alarms to appear one after another for the Cycle alarms
time.
b) Only one active with highest priority (last in Project tree) will cause only one alarm to appear,
the one with the highest priority. The highest priority is understood to mean the location in the
Project tree. The alarm located at the end has the highest priority.
Page 113/137
To Next Page
Loading...
General